ALLEN & HEATH iLIVE Bedienungsanleitung PDF herunterladen (Seite 98)

iLive Reference Guide – Firmware Part 2 - 98 AP6526-2 iss.5

System fails to connect

If you get the CONNECTION FAILED screen when you boot the

system up:

Check that the cables connecting the MixRack and Surface are

correctly plugged in and are not damaged. If you are using a two

cable connection check that they are not crossed over or plugged

into the wrong sockets.

ACE connection Make sure the CAT5 cable is plugged into the ACE

sockets, not NETWORK at each end. Do Not plug in a second

NETWORK cable if you are connecting a fixed format iLive with ACE.

The network is bridged over the ACE connection.

If you are using a single cable connection via the ACE option card in

the modular iLive RAB2 Port A slot then make sure the NETWORK

connection is bridged at both ends using short CAT5 jumper cables.

Network connections (select a MixRack) Touch the Network

Connections button. If you are attempting to connect to a MixRack

with a name or network address that has been changed or to one that

is different to the last rack connected, you may need to select it using

this screen.

Touch the Change MixRack button to open a list of MixRacks

recognised on the network. Select the MixRack you want to connect

to and touch Apply and Restart.

Dual-Rack settings If the Master and Slave MixRack in a Dual-Rack

system have the same IP address then they will not connect and the

system will hang due to network conflict. This may be the case if both

MixRacks have had their IP addresses reset to the default

192.168.1.1. Make sure each MixRack has a compatible but unique IP

address before connecting them together. You can set this by

resetting one MixRack and connecting the other to the Surface or

Editor to change its IP address before connecting the first.

If a MixRack left in Slave mode is connected to a Surface as a single

rack system it will also fail to connect. Reset its network settings

using the recessed switch as described earlier in this guide.

Reset network IP addresses If the MixRack is not recognised then

its IP address or operating mode may not be compatible with the rest

of the system. In this case reset the 3 network addresses to factory

default so that the MixRack, Surface and TouchScreen can see each

other and reconnect. Once reconnected you can change the network

settings to suit your application. Reset the network settings as

described earlier in this guide.

Note: Resetting the addresses in this way should only be done if

you are using a single stand alone system. Do not do this if you are

connected to a DHCP server or system network with other devices

connected. For complex network arrangements refer to your IT

manager or use standard networking tools to diagnose problems.

For further diagnostics you could try connecting a laptop running

iLive Editor to 'MixRack + Surface', or to 'MixRack only'.

If you need further help please contact Allen & Heath Tech Support in

your area.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 106 107

Kommentare zu diesen Handbüchern

Keine Kommentare

ALLEN & HEATH iLIVE Bedienungsanleitung Seite 98

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für DJ-Controller ALLEN & HEATH iLIVE